Kia Sorento: Release Residual Pressure in Fuel Line

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Release Residual Pressure in Fuel Line

Whenever the high pressure fuel pump, fuel pipe, delivery pipe, or injector is removed immediately after shutting off the engine, an injury may be caused by the release of highly pressurized fuel. Release the residual pressure in the high pressure fuel line by referring to the "Residual fuel pressure release procedure" below before removing any high pressure fuel system components.

Wear safety glasses and fuel resistant gloves.

1.	Turn the ignition off and disconnect the battery negative cable.

2.	Remove the fuel pump fuse (A).

3.	Disconnect the electrical connector from the high pressure fuel pump.

4.	Reconnect the battery negative cable.

5.	Run the engine for about 20 seconds to lower the pressure in both the high or low pressurelines. The engine may shut off within the 20 second period. If not, turn the engine off.

6.	Proceed with the service or repair. Use rags to cover opening and catch spills when opening up the high pressure system.

7.	Reinstall / re-connect all components in reverse order of removal. Start engine and confirm proper operation, and make sure there are no fuel leaks.

8.	After completing, clear DTC(s) using GDS scan tool (the procedure described above will cause DTC to set).

Fuel Pressure Test (Low pressure system)

1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line") ...

Fuel Tank Removal

1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line") ...

Kia Sorento: Release Residual Pressure in Fuel Line

Fuel Pressure Test (Low pressure system)

Fuel Tank Removal

See also:

Categories