Kia Sorento: Inspection - Variable Intake Solenoid (VIS) Valve - Engine Control System - Engine Control / Fuel System - Kia Sorento XM 2011-2024 Service ManualKia Sorento: Inspection

Second Generation XM (2011-2024) / Kia Sorento XM 2011-2024 Service Manual / Engine Control / Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve / Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between VIS valve terminals 1 and 2.

Specification: Refer to "Specification"

Circuit Diagram
...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the variable intake solenoid valve connector ( ...

See also:

Rear Bumper Components
1. Rear bumper cover 2. Rear bumper lower bracket [RH] 3. Rear bumper lower bracket [LH] 4. Rear bumper side bracket [RH] 5. Rear bumper side bracket [LH] ...

3. TCM Terminal input/ output signal
Connector [A] Pin No. Signal Condition Type Level 29 Sports mode up switch Up ON Input 0V/Battery voltage level ...

Engine Control Module (ECM) Installation
1. Install in the reverse order of removal. ECM installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m,7.2 ~ 8.7 lb-ft) ECM ...

Copyright В© www.ksmanual.com 2014-2024