Kia Sorento: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the CVVT oil control valve connector (A).
|
| 3. |
Remove the installation bolt (B), and then remove the valve from
the engine.
[Bank 1 / Intake]
[Bank 1 / Exhaust]
|
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV termina ...
Installation
•
Install the component with the specified torques.
•
...
See also:
Front Fog Lamps Inspection
1.
With the fog lamp switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the multifunctio ...
Hands Free Switch Installation
1.
Install the handsfree remote switch to the steering wheel front
cover.
2.
Install the steering wheel front cover.
3 ...
Temperature Control Actuator Replacement
[Driver's side]
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the driver's si ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026