Kia Sorento: Circuit Diagram

Specification

Accelerator Position Output Voltage (V) APS1 APS2 C.T 0.7 ~ 0.8 0.275 ~ 0.475 W.O.T 3.8 ~ 4.4 1.75 ~ 2.35 ...

Inspection

1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the output volt ...

See also:

Rear Lower Arm Inspection
1. Check the bushing for wear and deterioration. 2. Check the rear lower arm for deformation. ...

Battery saver function
The purpose of this feature is to prevent the battery from being discharged if the lights are left in the ON position. The system automatically shuts off the parking lights 30 seconds after the ...

Crankshaft Damper Pulley Removal and Installation
1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the passenger engine room side cover. (Ref ...