Kia Sorento: Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
| •
|
Apply the engine oil to the O-ring.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage.
|
|
| •
|
Be careful not to damage the sensor housing and the connector.
|
| •
|
Be careful not to damage the O-ring.
|
|
|
1. |
Install in the reverse order of removal.
Camshaft position sensor installation
bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
•
DON’T remove the camshaft position sensor while the engine
is running or right aft ...
Knocking is a phenomenon characterized by undesirable vibration and noise
and can cause engine damage. Knock Sensor (KS) is installed on the cylinder
block and senses engine knocking.
Whe ...
See also:
Windshield Deicer Switch Installation
1.
Install the heater control unit.
2.
Install the center fascia panel.
...
Adjustment
After replacing ETC module or ECM, the ETC adaptive value must be reset
/ relearned according to the following procedure.
1.
Check DTC(s) and clear if exist.
...
Specifications
Direct control VFS[OD/C]
▷ Control type : Normal high type
Control Pressure kpa
(kgf/cm², psi)
539.370 ~ 0 ( 5.5 ~ 0, 78.23 ~ 0)
Current value(mA)
...
Removal
Knock Sensor (KS)