Kia Optima Manuals

Kia Sorento: Removal - Camshaft Position Sensor (CMPS) - Engine Control System - Engine Control / Fuel System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Control / Fuel System / Engine Control System / Camshaft Position Sensor (CMPS) / Removal

  
•
DON’T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.
[Bank 1 / Intake]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the camshaft position sensor connector (A).
3.
Remove the installation bolt (B), and then remove the sensor.
[Bank 1 / Exhaust]
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the camshaft position sensor connector (A).
3.
Remove the hanger and the protector.
4.
Remove the installation bolt (B), and then remove the sensor.
Inspection
1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” ...

Installation
   • Install the component with the specified torques. • ...

See also:

Voice Command List
Common Commands: These commands can be used in most operations. (However a few commands may not be available during certain operations) FM/AM radio commands: Commands available during FM, ...

TPMS Sensor Description
1. Mode (1) Configuration State A. All sensors should be in the Low Line state. ...

Fuel Filter Installation
1. Install in the reverse order of removal. ...

Categories

Copyright www.ksmanual.com 2014-2026