Kia Sorento: Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
| •
|
Apply the engine oil to the O-ring.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage.
|
|
|
1. |
Install in the reverse order of removal.
Crankshaft position sensor installation
bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7
lb-ft)
Crankshaft position sensor protector
installation bolt (M6): 9.8 ~ 11.8 N.m (1.0 ~ 1.2
kgf.m, 7.2 ~ 8.7 lb-ft)
Crankshaft position sensor protector
installation bolt (M8): 18.6 ~ 23.5 N.m (1.9 ~
2.4 kgf.m, 13.7 ~ 17.4 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the crankshaft position sensor connector (A).
...
Camshaft Position Sensor (CMPS) is a hall sensor and detects the camshaft
position by using a hall element.
It is related with Crankshaft Position Sensor (CKPS) and detects the piston
pos ...
See also:
Radiator Removal and Installation
1.
Disconnect the battery terminals.
2.
Remove the air cleaner assembly.
(Refer to Intake And Exhaust System - "Air Cleaner" ...
Transmitter Code Registration (Using GDS)
1.
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
2.
...
Head Lamps Adjustment
Head Lamp Aiming Instructions
The head lamps should be aimed with the proper beam-setting equipment,
and in accordance with the equipment manufacturer's instructions.
...
Removal
Camshaft Position Sensor (CMPS)