Kia Optima Manuals

Kia Sorento: Installation - ETC (Electronic Throttle Control) System - Engine Control System - Engine Control / Fuel System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Control / Fuel System / Engine Control System / ETC (Electronic Throttle Control) System / Installation

  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Install in the reverse order of removal.
Electronic throttle body Installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the resonator and the air intake hose. (Re ...

Adjustment
After replacing ETC module or ECM, the ETC adaptive value must be reset / relearned according to the following procedure. 1. Check DTC(s) and clear if exist. ...

See also:

Drive Belt Removal and Installation
1. For release the tension, turn the drive belt tensioner counterclockwise then remove the drive belt (A). 2. Install the drive be ...

Oil Seal Replacement
[Right side] 1. Remove the front muffler. (Only gasoline 3.3) (Refer to Engine Mechanical System - "Front Muffler ") 2. Re ...

Installation
   • Install the component with the specified torques. • ...

Categories

Copyright www.ksmanual.com 2014-2026