Kia Sorento: Inspection
Throttle Position Sensor (TPS)
| 1. |
Connect the GDS on the Data Link Connector (DLC).
|
| 2. |
Start the engine and measure the output voltage of TPS 1 and 2
at C.T. and W.O.T.
|
| 3. |
Turn the ignition switch OFF and disconnect the scantool from
the DLC.
|
| 4. |
Disconnect the ETC module connector and measure the resistance
between the ETC module terminals 1 and 2.
|
ETC Motor
| 1. |
Turn the ignition switch OFF.
|
| 2. |
Disconnect the ETC module connector.
|
| 3. |
Measure resistance between the ETC module terminals 3 and 6.
|
| 4. |
Check that the resistance is within the specification.
|
Circuit Diagram
...
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the resonator and the air intake hose.
(Re ...
See also:
Telemetics Unit (TMU) Component
Connector Pin Specification
No.
Pin Name
Type
From
To
Description (Wiring Spec.)
1
GND
DC Ground
TMU
Battery
...
Block Diagram
...
ATF Warmer Component
1. ATF Warmar
2. Bypass valve
3. ATF hose & pipe
4. Coolant hose & pipe
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026