Kia Sorento: Engine Control Module (ECM) Installation

Engine Control Module (ECM) Removal

1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the ECM Connector (A). ...

ECM Problem Inspection Procedure

1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...

See also:

Immobilizer Control Unit Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel (A). (Refer to Body - "Crash pad") ...

Starter Disassembly
1. Disconnect the M-terminal (A) on the magnet switch assembly (B). 2. After loosening the screws (A), detach the magnet switch assembly ...

Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the FTPS. Specification: ...