Kia Sorento: Inspection

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Emission Control System / Crankcase Emission Control System / Inspection

1.	After disconnecting the vapor hose from the PCV valve, remove the PCV valve.

2.	Reconnect the PCV valve to the vapor hose.

3.

Inspect the PCV vlave operation.

(1)	Run the engine at idle.

(2)	Put a finger on the open end of the PCV valve.

(3)	Make sure that intake manifold vaccum can be felt.

The plunger inside the PCV valve will move back and forth at vacuum.

4.	If the vacuum is not felt, clean or replace the vapor hose.

Schematic Diagram

...

Positive Crankcase Ventilation (PCV) Valve Operation Principle

...

See also:

Starter Inspection
Starter Solenoid Inspection 1. Disconnect the lead wire from the M-terminal of solenoid switch. 2. Connect the battery as shown. If ...

Rear Body
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Side outer p ...

2. TCM terminal function
Connector [A] Pin Description Pin Description 1 - 45 Inhibitor switch signal 'S2' 2 - 46 Inh ...

Categories

Copyright © www.ksmanual.com 2014-2026