Kia Optima Manuals

Kia Sorento: Oil Pan Removal - Lubrication System - Engine Mechanical System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Oil Pan Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Mechanical System / Lubrication System / Oil Pan Removal

1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the A/C compressor.
(Refer to Heating, Ventilation, Air Conditioning - "Compressor")
3.
Remove the A/C compressor bracket (A).

4.
Drain the engine oil.
5.
Remove the oil pan (A). Insert the blade of SST (09215-3C000) between the ladder frame and oil pan. Cut off applied sealer and remove the lower oil pan.

  
•
Insert the SST between the oil pan and the ladder frame by tapping it with a plastic hammer in the direction of arrow.
•
After tapping the SST with a plastic hammer along the direction of arrow around more than 2/3 edge of the oil pan, remove it from the ladder frame.
•
Do not turn over the SST abruptly without tapping. It be result in damage of the SST.
Oil Cooler Installation
1. Apply a light coat of engine oil to the oil cooler packing surface (A), and then install the oil cooler with fix bolt (B). Tightening torque: ...

Oil Pan Installation
1. Install the oil pan. (1) Using a gasket scraper, remove all the old sealant material from the gasket surfaces. ...

See also:

Schematic Diagram
...

Rear combination lamp Removal
1. Disconnect the negative (-) battery terminal. [Outside] 2. Loose the screws (2EA) holding the rear combination lamp then disconn ...

Air Ventilation Seat Control Unit Installation
1. Install the air ventilation seat control unit and connector. ...

Categories

Copyright www.ksmanual.com 2014-2026