Kia Sorento: Piston and Connecting Rod Disassembly
| • |
Use fender covers to avoid damaging painted surfaces.
|
| • |
To avoid damage, unplug the wiring connectors carefully while
holding the connector portion.
|
|
| • |
Mark all wiring and hoses to avoid misconnection.
|
| • |
Turn the crankshaft pulley so that the No.1 piston is at top
dead center.
|
| • |
Engine removal is required for this procedure.
|
|
|
In case of removing the high pressure fuel pump, high pressure fuel
pipe, delivery pipe, and injector, there may be injury caused by leakage
of the high pressure fuel. So don’t do any repair work right after engine
stops.
|
|
1. |
Remove the ladder frame.
(Refer to Cylinder Block - "Ladder Frame")
|
|
2. |
Check the connecting rod end play.
|
|
3. |
Remove the connecting rod caps and check oil clearance.
|
|
4. |
Remove piston and connecting rod assemblies.
|
(1) |
Using a ridge reamer, remove all the carbon from the top of
the cylinder.
|
|
(2) |
Push the piston, connecting rod assembly and upper bearing through
the top of the cylinder block.
|
| •
|
Keep the bearings, connecting rod and cap together.
|
| •
|
Arrange the piston and connecting rod assemblies in
the correct order.
|
|
|
|
5. |
Check fit between piston and piston pin.
Try to move the piston back and forth on the piston pin. If any movement
is felt, replace the piston and pin as a set.
|
|
6. |
Remove piston rings.
|
(1) |
Using a piston ring expander, remove the 2 compression rings.
|
|
Arrange the piston rings in the correct order only.
|
|
1. Piston ring
2. Snap ring
3. Piston
4. Connecting rod
5. Connecting rod upper bearing
6. Connecting rod lower bearing
7. Connecting rod bearing cap
...
Connecting Rod
1.
Check the connecting rod end play.
Using a feeler gauge, measure the end play while moving the connecting
rod back and forth.
...
See also:
Oil hydraulic Motor(Actuator) Description
The 4WD ECM controls the Pump Motor Pump (Actuator) to generating an oil
pressure. The pressure engages a multiple disk clutch to transfer torque to
the rear wheels. The torque to the rear wh ...
Troubleshooting
•
The battery must be in good condition and fully charged
for this troubleshooting.
...
In-car Sensor Inspection
1.
Turn the ignition switch ON.
2.
Blow air with changing temperature into the in-car sensor air
inlet. Measure the sensor resistance betwe ...
Piston and Connecting Rod Components
Piston and Connecting Rod Inspection