Kia Sorento: Rear Oil Seal Installation - Cylinder Block - Engine Mechanical System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Rear Oil Seal Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Installation

1.
Install rear oil seal.
(1)
Apply engine oil to a new oil seal lip.
(2)
Using SST(09231-H1100, 09214-2W200) (B) and a hammer, tap in the oil seal (A) until its surface is flush with the rear oil seal retainer edge.

2.
Install the drive plate.
(Refer to Cylinder Block - "Drive Plate")
3.
Install the automatic transaxle.
(Refer to Automatic Transaxle System - "Automatic Transaxle")
Rear Oil Seal Removal
1. Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle") 2. Remove the drive plate. ...

Ladder Frame Removal
   • Use fender covers to avoid damaging painted surfaces. • ...

See also:

Removal
1. Remove the engine cover. (Refer to Engine Mechanical System - "Engine cover") 2. Remove the air cleaner assembly and air du ...

Seat Belt Pretensioner (BPT) Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least thirty seconds. ...

Seat belt restraint system
WARNING For maximum restraint system protection, the seat belts must always be used whenever the vehicle is moving. Seat belts are most effective when seatbacks are in the upright position. ...

Copyright www.ksmanual.com 2014-2026