Kia Sorento: Idler Removal and Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Mechanical System / Timing System / Idler Removal and Installation

1.	Remove the drive belt. (Refer to Timing System - "Drive Belt")

2.

Remove the idler(A).

Tightening torque :

53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft)

Check the idler. if it is grease leak or abnormal rotation, replace the idler.

3.	Install in the reverse order of removal.

Drive Belt Inspection

1. Visually check the belt for excessive wear, frayed cords etc. If any defect has been found, replace the drive belt. ...

Drive Belt Tensioner Removal and Installation

1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the drive belt auto tensioner(A). ...

See also:

Fuel Filler Door Release Actuator Inspection
1. Remove the fuel filler cover (A) after loosening screws (2EA). 2. Remove the fuel filler door module (A). ...

3. TCM Terminal input/ output signal
Connector [A] Pin No. Signal Condition Type Level 29 Sports mode up switch Up ON Input 0V/Battery voltage level ...

Blower Resistor Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the passenger side crash pad under cover (A). 3. ...

Categories

Copyright © www.ksmanual.com 2014-2026