1. |
Disconnect the negative (-) battery terminal.
|
2. |
Recover the refrigerant with a recover/recycling/charging station.
|
3. |
When the engine is cool, drain the engine coolant from the radiator.
|
4. |
Remove the rear luggage side trim.
(Refer to Body - "Interior Trim")
|
5. |
Remove the rear wheel guard.
(Refer to Body - "Body Side Moldings")
|
6. |
Loosen the refrigerant line mounting nuts, and then remove the
rear refrigerant line (A).
|
7. |
Loosen the refrigerant line mounting bolts, and then remove the
rear upper refrigerant line (A).
|
8. |
Remove the rear heater unit after disconnecting the connectors
and loosening the mounting bolts.
|
9. |
Remove the evaporator core cover (A).
|
10. |
Remove the evaporator core (A).
|
11. |
Install in the reverse order of removal.
|
Circuit Diagram
Connector Pin Information
No.
Wire harness connector
Panorama motor
Blind motor
1
Ground 1 ...
Auto Light Sensor Installation
1.
Reconnect the auto light connector.
2.
Install the auto light sensor.
...
ATF Warmer Component Location
1. ATF Warmar
2. Bypass valve
3. ATF hose & pipe
4. Coolant hose & pipe
...