1. |
Measure the resistance between the terminals.
|
2. |
If the measured resistance is not within specification, the blower
resistor must be replaced. (After removing the resistor)
|
Roller Blind Motor Replacement
1.
Refer to the inspection procedure in the panorama sunroof motor.
(Refer to the "Panorama Sunroof Motor")
...
Engine Control Module (ECM) Adjustment
•
After replacing the ECM of the vehicle with the immobilizer, the
following procedure must be performed.
1)
[If installing a used ECM]
...
Rear Air Conditioner Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recover/recycling/charging station.
3.
...