1. |
Measure the resistance between the terminals.
|
2. |
The measured resistance is not within specification, the blower
resistor must be replaced. (After removing the resistor)
|
Inspection
1.
Remove the cowl top cover.
(Refer to the wiper)
2.
Disconnect the windshield deicer connector (A) from the wiper
motor linkage.
...
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output volt ...
Fuel Line Removal
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to the F ...