Kia Sorento: Mode Control Actuator Replacement
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Heating,Ventilation And Air Conditioning / Heater / Mode Control Actuator Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Using a screwdriver or remover, remove the driver's side crash
pad side cover.
|
| 3. |
After loosening the mounting screws, remove the crash pad lower
panel (A).
|
| 4. |
Push the lock pin (B), disconnect the diagnosis connector (C).
|
| 5. |
After loosening the mounting bolts, then remove the reinforce
panel (A).
|
| 6. |
Remove the driver's side shower duct after loosening the screw.
|
| 7. |
Disconnect the connector and then remove the mode control actuator
(A) after loosening the mounting screws.
|
| 8. |
Install in the reverse order of removal.
|
Mode Control Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode con ...
Auto Defogging Actuator Description
The auto defogging sensor is installed on front window glass. The sensor
judges and sends signal if moisture occurs to blow out wind for defogging. The
air conditioner control module receives ...
See also:
Flex Steering Instruction
Flex Steering is system to choose the three modes power steering depending
on driver preference or driving conditions.
...
Compressor Installation
1.
Make sure the compressor mounting bolt with the correct length
is screwed in. Tighten the mounting bolts with the specified tightening
order.
...
Cylinder Head Reassembly
Thoroughly clean all parts to be assembled.
Before installing the parts, apply fresh engine oil to all sliding and
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026