1. |
Measure the pressure of high pressure line by measuring voltage
output between terminal “1” and “2”.
|
2. |
Inspect the voltage value whether it is sufficient to be regular
value or not.
|
3. |
If the measured voltage value is not wihtin specification, replace
the A/C pressure transducer.
|
Components Location
1. PCV Valve
2. Canister
3. Purge Control Solenoid Valve (PCSV)
4. Fuel Tank Pressure Sensor (FTPS)
5. Canister Close Valve (CCV)
6. Fuel Level Sender (FLS)
7. Fuel Ta ...
Front Washer Motor Inspection
Front and Rear Washer Motor
1.
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
&nb ...
TJ Joint Installation
1.
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boot.
2.
Using the alignment marks (D) made during disassembly as a ...