Kia Optima Manuals

Kia Sorento: Hazard Lamp Switch Removal - Lighting System - Body Electrical System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Hazard Lamp Switch Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Lighting System / Hazard Lamp Switch Removal

  
•
Put on gloves to protect your hands.
  
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or remover, remove the center fascia panel (A).
3.
Remove the heater control unit connectors (A).
4.
Remove the heater control unit (A) with hazard switch.
(Refer to HA group - "Heater & A/C Control Unit")
Door Mood Lamp Installation
1. Install the door mood lamp and connector. 2. Install the front door trim. 3. Connect the negative battery te ...

Hazard Lamp Switch Installation
1. Install the heater control unit to the center fascia panel. 2. Install the center fascia panel. ...

See also:

CVVT & Camshaft Components
1. Camshaft bearing cap 2. Camshaft front bearing cap 3. Exhaust camshaft 4. Intake camshaft 5. Exhaust CVVT assembly 6. Intake CVVT assembly 7. Exhaust camshaft upper ...

Quarter Fixed Glass Installation
1. With a putt knife, scrape the old adhesive smooth to a thickness of about 2mm (0.08 in.) on the bonding surface around the entire quarter fixed glass flange. ...

Components
1. Blind Spot Detection (BSD) Unit 2. BSD switch 3. Speaker (Built in the cluster) 4. BSD warning lamp (Built in the outside mirror) ...

Categories

Copyright www.ksmanual.com 2014-2026