Kia Optima Manuals

Kia Sorento: Panorama Sunroof Motor Inspection - Panorama Sunroof - Body Electrical System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Panorama Sunroof Motor Inspection

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Panorama Sunroof / Panorama Sunroof Motor Inspection

1.
Close the panorama sunroof glass and blind completely (Full close position).
2.
Disconnect the negative (-) battery terminal.
3.
Remove the roof trim assembly.
(Refer to Body - "Roof Trim")
4.
Remove the panorama sunroof glass motor (A) after loosening the screws and disconnecting the connector.
5.
Check the wiring connector of the panorama sunroof glass motor as below table.
Terminal
 Test condition
 Test : Desired result
3 - GND
 IG2 ON
 Check for voltage to ground :
There should be battery voltage
1 - GND
 Under all conditions
 Check for continuity to ground :
There should be continuity.
6 - GND
 Under all conditions
 Check for voltage to ground :
There should be battery voltage.

6.
Remove the blind motor (A) after loosening the screws and disconnecting the connector.
7.
Check the wiring connector of the blind motor as below table.
Terminal
 Test condition
 Test : Desired result
1 - GND
 Under all conditions
 Check for continuity to ground :
There should be continuity.
6 - GND
 Under all conditions
 Check for voltage to ground :
There should be battery voltage.

8.
Connect the panorama sunroof glass and blind motor and each connectors.
  
Be careful not to reinstall the motors on the panorama sunroof.
9.
Connect the negative (-) battery terminal.
10.
Start the vehicle engine.
11.
Check the motor's operation by pressing the panorama sunroof switch.
Terminal
 Operation Test
Auto open
switch
 Both the glass and blind motors operate
Auto close
switch
 Both the glass and blind motors operate
Auto tilt up
switch
 Both the glass and blind motors operate
Blind open
switch
 The blind motor operates
Blind close
switch
 The blind motor operates

12.
Pless the auto close switch after checking the motor's operation.
13.
Install the panorama sunroof glass motor and blind motor. And then perform the resetting procedure of the panorama sunroof.
  
Use only the auto close switch.
Panorama Sunroof Switch Inspection
1. Disconnect the negative (-) battery terminal. 2. Open the sunglass case cover from the overhead console then remove the 2 screws holding ...

Panorama Sunroof Motor Replacement
Resetting The Panoramaroof Whenever the vehicle battery is disconnected or discharged, or you use the emergency handle to operate the panoramaroof, you have to reset your panoramaroof sys ...

See also:

Occupant Detection system (ODS) Description
In order to make normal activation of airbag system, SRSCM detects DTC(s) for the Passenger side Body Detection System. If the seat is occupied, Body sensor detects how measuring electrostati ...

Specifications
Direct control VFS[LINE Pressure] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 539.370 ~ 0 ( 5.5 ~ 0, 78.23 ~ 0) Current va ...

Power Door Mirror Switch Inspection
1. Remove the front door trim and power door mirror switch module (A). (Refer to Body - "Front door") 2. Check fo ...

Categories

Copyright www.ksmanual.com 2014-2026