1. |
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
|
2. |
Remove the front bumper cover.
(Refer to Body - "Front bumper")
|
3. |
Connect positive (+) and negative (-) battery cables to terminals
3 and 2 respectively to see that the washer motor runs and water is
pumped.
|
4. |
Check that the motor operates normally.
Replace the motor if it operates abnormally.
[Front & Rear washer]
1. Windshield washer (+)
2. Ground
3. Rear washer (+)
|
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the PCSV connector.
3.
Measure resistance between the PCSV termi ...
Teaching Procedures
1.
Key Teaching Procedure
Key teaching must be done after replacing a defective PCM(ECM)
or when providing additional keys to the vehicle owner.
The procedu ...
Occupant Detection system (ODS) Description
In order to make normal activation of airbag system, SRSCM detects DTC(s)
for the Passenger side Body Detection System. If the seat is occupied, Body
sensor detects how measuring electrostati ...