Kia Sorento: Rear Wiper Motor Removal
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Wiper Motor Removal
| 1. |
Detach the rear wiper cap (A).
|
| 2. |
Remove the rear wiper arm & blade (A) after removing rear wiper
HEX nut (B).
|
| 3. |
Open the tailgate then remove the tailgate trim.
(Refer to Body - "Tailgate")
|
| 4. |
Disconnect the rear wiper motor connector (B) then remove the
rear wiper motor (A) after loosening bolts (3EA).
|
Rear Wiper Motor Inspection
Rear Wiper Motor
1.
Remove the 4P connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals ...
Rear Wiper Motor Installation
1.
Install the rear wiper motor assembly.
Tightening torque Nut :
7 ~ 11 N.m (0.7 ~ 1.1 kgf.m, 5 ~ 7.9 lbf-ft)
...
See also:
Component Location
1. Head lamp leveling sensor & unit
2. Head lamp leveling actuator
...
SS-B Solenoid Valve(ON/OFF)
SS-B solenoid valve is attached to the valve body and is an on/off solenoid
valve that is used to change gears.
SS-B Solenoid valve(ON/OFF) is installed at valve body.
...
Circuit Diagram
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026