Kia Sorento: Rear Wiper Motor Inspection
| 1. |
Remove the 4P connector from the rear wiper motor.
|
| 2. |
Connect battery positive (+) and negative (-) cables to terminals
3 and 4 respectively.
|
| 3. |
Check that the motor operates normally. Replace the motor if it
operates abnormally.
1. IGN +
2. Parking
3. Switch
4. Ground
|
| 1. |
Operate the motor at low speed using the stalk control.
|
| 2. |
Stop the motor operation anywhere except at the off position by
disconnecting terminal 3.
|
| 3. |
Connect terminals 2 and 3.
|
| 4. |
Connect the positive (+) lead from the battery to terminal 1 and
the negative (-) lead to terminal 4.
|
| 5. |
Check that the motor stops running at the off position.
|
Component Location
Rear Wiper Motor RemovalComponents
1. Telematics unit (TMU)
2. Roof Antenna (GPS)
3. AUX jack
4. AVN head unit
5. Mic
...
Smart key precautions
The smart key will not work if any of the following occur: The smart key
is close to a radio transmitter such as a radio station or an airport which
can interfere with normal operation of the s ...
Passenger Airbag (PAB) Module Description
Passenger Airbag (PAB) module is located in the passenger crash pad. This
PAB contains 2 firing squibs of airbag and 1 firing squib of active vent. Depending
of crash speed or the tightening ...