|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front bumper cover.
(Refer to Body - "Front bumper")
|
3. |
Remove the washer hose and disconnect the washer motor connector
(A) and washer fluid level sensor connector (B).
|
4. |
Remove the washer motor (A).
|
5. |
Remove the washer reservoir after removing bolts (A).
|
Input Speed Sensor Signal Waveform
...
Power Seat Control Switch Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...
Auto Defogging Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the auto defogging connector.
3.
Verify that the auto defoggin ...