Kia Sorento: Anti-Pinch Strip Removal
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Power Tailgate Module / Anti-Pinch Strip Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
After loosening the mounting screws, then remove the tailgate
side trim (A).
(Refer to Body - "Tailgate")
|
| 3. |
Remove the anti-pinch strip sensor connector.
|
| 4. |
Remove the anti-pinch strip (A) after removing the clips (5EA).
|
Power Tailgate Latch Inspection
Power Tailgate Inspection With GDS
1.
Check the power Tailgate module input/output value by using the
GDS. If the operation of power Tailgate module is abnormal, replac ...
Anti-Pinch Strip Installation
1.
Install the tailgate anti-pinch strip.
2.
Install the tailgate side trim.
3.
Connect the negative (-) batter ...
See also:
Filter replacement
It must be replaced when necessary, and should not be washed.
You can clean the filter when inspecting the air cleaner element. Clean the filter
by using compressed air.
1. Loosen the air clean ...
Side air bag
Your vehicle is equipped with a side air bag in each front seat. The purpose
of the air bag is to provide the vehicle's driver and/or the front passenger with
additional protection than that o ...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis
ground using the backside of ECM harness connector as ECM side check
point. If the problem is fo ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026