Kia Sorento: Power Window Motor Inspection
| 1. |
Remove (-) negative battery terminal.
|
| 2. |
Remove the front door trim.
(Refer to Body - "Front door")
|
| 3. |
Disconnect the connector from the motor.
(A : Safety, B : Standard)
|
| 4. |
Connect the terminal No. 2 and No. 3 to battery voltage (12V)
and check that the motor operates smoothly when connecting the terminals
below.
|
| 5. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
|
| 1. |
Remove (-) negative battery terminal.
|
| 2. |
Remove the rear door trim.
(Refer to Body - "Rear door")
|
| 3. |
Disconnect the connector from the motor.
|
| 4. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
|
Operation
Power Window Switch ComponentsComponents Operations
PCM (Power Train Control Module)
1.
The PCM(ECM)(A) carries out a check of the ignition key using
a special encryption algorithm, which is programmed into the transpond ...
SS-B Solenoid Valve(ON/OFF)
SS-B solenoid valve is attached to the valve body and is an on/off solenoid
valve that is used to change gears.
SS-B Solenoid valve(ON/OFF) is installed at valve body.
...
Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
...