Kia Sorento: Seat Heater Switch Inspection
Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Body Electrical System / Seat Electrical / Seat Heater Switch Inspection
Front Seat Heater Switch
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the center fascia panel (A).
(Refer to Body - "Crash pad")
|
| 3. |
Disconnect the connectors and cables (A) from center fascia panel.
|
| 4. |
Remove the driver and assist seat heater switch connector.
|
| 5. |
Check that continuity exists between the terminals after turning
the driver seat heater switch ON.
|
| 6. |
If the switch fails to operate, replace the driver and assist
seat heater switch (A).
|
2nd Seat Heater Switch
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the floor console rear cover (A).
(Refer to Body - "Console")
|
| 3. |
Turn 2nd seat heater switch ON and check that continuity exists
between the terminals.
|
| 4. |
Replace the 2nd seat heater switch.
|
Power Seat Control Switch Installation
1.
Install the power seat control switch after connecting the connector.
...
See also:
Front Body B
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...
Description
EPS (Electric power steering, Column assist type) system uses an electric
motor to assist the steering force and it is an engine operation independent
steering system.
EPS control module ...
ECM Terminal And Input/Output signal
ECM Terminal Function
Connector [C300-A]
Pin
No.
Description
Connected to
1
Ignition Coil (Cylinder #2) control output
[NON-smart ke ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2025 Owners Manual
- Kia Sorento XM 2011-2025 Service Manual
Copyright www.ksmanual.com 2014-2025