Kia Sorento: Smart key unit Installation
| 1. |
Install the smart key unit.
|
| 2. |
Install the smart key unit mounting bolt and nut, and then connect
the connector.
|
| 3. |
Install the glove box.
|
| 4. |
Install the negative (-) battery terminal and check the smart
key system.
|
| 1. |
Install the interior 1 antenna.
|
| 2. |
Install the console assembly.
|
| 3. |
Install the negative (-) battery terminal and check the smart
key system.
|
| 1. |
Install the interior 2 antenna.
|
| 2. |
Install the connector mounting bracket.
|
| 3. |
Install the console rear cover after connecting the connector.
|
| 4. |
Install the negative (-) battery terminal and check the smart
key system.
|
| 1. |
Install the interior 3 antenna.
|
| 2. |
Install the third seat assembly.
|
| 3. |
Install the negative (-) battery terminal and check the smart
key system.
|
| 1. |
Install the exterior bumper antenna.
|
| 2. |
Install the rear bumper.
|
| 3. |
Install the negative (-) battery terminal and check the smart
key system.
|
| 1. |
Install the buzzer.
|
| 2. |
Install the front left wheel guide.
|
| 3. |
Install the negative (-) battery terminal and check the smart
key system.
|
| 1. |
Install the outside handle.
|
| 2. |
Install the door trim.
|
| 3. |
Install the negative (-) battery terminal and check the smart
key system.
|
| 1. |
Install the tailgate switch.
|
| 2. |
Install the tailgate garnish.
|
| 3. |
Install the tailgate trim.
|
| 4. |
Install the negative (-) battery terminal and check the smart
key system.
|
Smart key unit Inspection
Smart Key Diagnostic InspectionRear parking assist system (If equipped)
The rear parking assist system assists the driver during backward movement of
the vehicle by chiming if any object is sensed within a distance of 47 in. (120
cm) behind the vehicle.
This system i ...
Body Side Moulding Replacement
Roof mouldingmoulding mouldingReplacement
[General Type]
•
Pry the trim off ...
Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The
top waveform is from the high side (feed side) of the #1 and #4 injectors, while
the middle waveform is from the low side ...