Kia Sorento: Inspection
Test the horn by connecting battery voltage to the 1 terminal and ground
the 2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace
it.
Horn Relay Inspection
| 1. |
Remove the horn relay (A) from the engine room relay box.
|
| 2. |
There should be continuity between the No.30 and No.87 terminals
when power and ground are connected to the No.85 and No.86 terminals.
|
| 3. |
There should be no continuity between the No.30 and No.87 terminals
when power is disconnected.
|
Installation
1.
Install the horns after connecting the horn connectors.
2.
Install the head lamp.
(Refer to "Lighting system")
...
Adjustment
1.
Operate the horn, and adjust the tone to a suitable level by turning
the adjusting screw.
...
See also:
Tightening Torques
Item
kgf.m
N.m
lb-ft
Positive Crankcase Ventilation (PCV) Valve installation
0.19 ~ 0.29
1.9 ~ 2.8
1.4 ~ 2.1
...
Filter replacement
It must be replaced when necessary, and should not be washed.
You can clean the filter when inspecting the air cleaner element. Clean the filter
by using compressed air.
1. Loosen the air clean ...
Heater & A/C Control Unit (DATC) Component
Connector Pin Function
Connector
Pin No
Function
Connector
Pin No
Function
A
1
Battery (+)
A
29
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026