Kia Sorento: Inspection
Lighting Switch Inspection
| 1. |
With the multi function switch in each position, make sure that
continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function
switch
Lighting switch (Auto light)
Lighting Switch
Dimmer And Passing Switch
Turn Signal Switch
Front Fog Lamp
|
Wiper And Washer Switch Inspection
| 1. |
With the multi function switch in each position, make sure that
continuity exists between the terminals below.
If continuity is not as specified, replace the multi-function
switch.
Wiper Switch
Washer Switch
Rear Wiper Switch
Rear Washer Switch
|
Installation
1.
Install the multifunction switch.
2.
Install the clock spring and steering wheel.
3.
Install the steering co ...
Inspection (With GDS)
1.
Check IPM input/output specification of multifunction switch using
the GDS. If the specification is abnormal, replace the lamp or wiper
switch.
...
See also:
Yaw-rate and G Sensor Installation
1.
Remove the ignition key from the vehicle.
2.
Install inthe reverse order of removal.
3.
After installing the ...
Troubleshooting
Ignition System
Symptom
Suspect Area
Remedy
Engine will not start or is hard to
start (Cranks OK)
Ignition lock switch
Inspect ignition ...
Troubleshooting
Symption
Suspect area
Remedy
Engine misfire with abnormal internal lower engine noises.
Worn crankshaft bearings
Loose or out of specification engine flywhe ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026